Serving Chico, CA and surrounding areas. (530) 924-5802
Thin or missing attic insulation turns your Chico home into an oven every summer. We fill the gaps fast, hit the right R-value, and handle the PG&E rebate paperwork.
Blown-in insulation in Chico fills attics and wall cavities with loose fiberglass or cellulose material blown through a large hose connected to a machine on our truck, covering irregular framing and corners that rigid batts cannot reach. Most attic jobs in an average-sized home are finished in one to three hours.
If your Chico home was built before 1980, there is a reasonable chance your attic has little insulation, or insulation that has settled and thinned over the decades. That gap between your ceiling and the summer heat is what drives your air conditioner to run longer and your PG&E bill to climb every June. Blown-in insulation is the most practical way to fix it without tearing into your home.
For homes where the attic already has coverage but conditioned air is still escaping through gaps around light fixtures and penetrations, pairing blown-in insulation with attic air sealing delivers the most complete result.
If rooms near your ceiling feel noticeably hotter than the rest of the house when Chico temperatures climb past 95 degrees, your attic insulation is too thin to do its job. A well-insulated attic acts as a thermal shield. Without it, summer heat radiates straight down into your living space all day.
If your electric bill climbs sharply in June and stays high through September even though your habits have not changed, your cooling system is working overtime against heat entering through a poorly insulated ceiling. Chico's triple-digit summer heat puts real pressure on under-insulated homes, and the cost shows up on your bill every month.
If you peek into your attic and can clearly see the wooden beams running across the floor, your insulation has settled significantly or was never installed to adequate depth. Insulation should cover those beams completely. If you can see them, you are losing energy every day.
Homes in Chico's established neighborhoods built before 1980 were constructed under much older standards. Many have little insulation in the attic, or insulation that has compressed and lost most of its effectiveness over the decades. If you have never had your insulation inspected or upgraded, there is a good chance it falls well below today's recommendations.
Our most common blown-in job is attic insulation, where we blow fiberglass or cellulose to the depth required to meet or exceed the R-38 to R-60 range recommended for Chico's climate zone. We measure multiple points across your attic before and after the job and leave depth markers so you can verify coverage yourself.
For existing walls, we use a dense-pack method, drilling small access holes from the exterior and filling each cavity before patching. This is a practical solution for Chico's older homes where no insulation was installed during original construction. Many homeowners pair this with a whole-home insulation assessment to prioritize which areas will deliver the best return.
When gaps around recessed lights, attic hatches, and plumbing penetrations are contributing to your energy loss, we also offer wall insulation and air-sealing work as part of the same project so we do not leave a half-solved problem behind.
Best for homeowners whose attic has inadequate or settled coverage and who want the fastest path to lower summer cooling bills.
Best for owners of pre-1980 Chico homes with uninsulated exterior walls who want improved comfort without tearing out interior finishes.
Best for homes that have some insulation but fall short of current R-value recommendations, often a faster and less expensive upgrade than a full removal and replacement.
Best for homes where air leaks around fixtures and penetrations are reducing the effectiveness of insulation, typically the highest-return combination for older Chico homes.
Chico sits in the northern Sacramento Valley and regularly sees summer temperatures above 100 degrees. That heat presses against your ceiling all day, and if your attic insulation is thin or absent, it transfers directly into your living space. Most of the homes in established Chico neighborhoods like the Avenues, Barber, and the areas near Chico State were built in the 1950s through 1970s under insulation standards far lower than today. If your home is in that range and you have never upgraded the attic, you have likely been overpaying on your PG&E bill for years.
Wildfire smoke is another local factor worth noting. Chico and Butte County have experienced significant smoke events, and homes with thin attic insulation and unsealed penetrations allow more outdoor air, including smoky air, to infiltrate than a properly insulated home does. Blown-in insulation, particularly when paired with air sealing, reduces those infiltration pathways.
We serve homeowners throughout the area, including Oroville, Yuba City, and Redding, where older housing stock and intense summer heat create the same conditions we see in Chico every day.
We ask a few basic questions about your home's age and what prompted your call. We reply within one business day and schedule a free in-home estimate at a time that works for you.
We visit, measure your existing insulation depth, and check for air leaks or moisture issues that should be addressed first. You receive a written quote stating the type of material, the target R-value, and the total cost. No surprise add-ons.
We set up the blowing machine outside and run a hose into your attic. Most single-story Chico homes are done in one to three hours. You can stay home. It is noisy near the truck but not disruptive inside.
Before we leave, we verify depth at multiple points, install depth markers so you can check coverage yourself, and provide the documentation you need for PG&E rebates and the federal tax credit. No drying time, the insulation works immediately.
Free estimate, written quote, no obligation. We reply within one business day.
(530) 924-5802Our California C-2 Insulation and Acoustical license is verifiable on the CSLB website before you hire us. When your project requires a City of Chico Building Division permit, we pull it, schedule the inspection, and are on site when the inspector arrives.
We measure insulation depth at multiple points across your attic and show you the results before we pack up. We also install depth markers so you can check coverage yourself years from now. The North American Insulation Manufacturers Association sets the installation standards we work to on every job.
We cover 12 communities from Chico and Oroville to Redding, Yuba City, Roseville, and Folsom. One crew handles the whole region, so you get a team that knows the local housing stock instead of a subcontractor who has never worked in your neighborhood before.
Chico homeowners served by PG&E may qualify for utility rebates on top of the current federal tax credit for insulation improvements. We know how these programs work, will tell you what your project qualifies for, and provide the documentation you need to claim both.
Good insulation work is invisible once it is in, which is exactly why we show you the results before we leave. A job done to the right R-value, verified on site, documented in writing, is one you can trust for the life of your home.
A whole-home insulation assessment covers attic, walls, and crawl space together so you know where to invest first.
Learn moreDense-pack wall insulation fills uninsulated exterior wall cavities in older Chico homes without tearing out interior finishes.
Learn moreSummer heat books our calendar fast. Call or submit a request today and we will get your free estimate scheduled before the busy season fills up.
